Product Description:
Our organization offers a superior quality range of Hydraulic Rod Cutter at industry leading price.
Features:
Forged alloy steel heat treated “C” frame type cylinder body used.
Single return spring design
Special quality sealing for specified pressure
High wear resistant Moving cutter guide square bushing for accurate cutter alignment
Easy to operate & maintain
Lighter in weight than Cast Steel design
Unique design of cutters and special steel used for longer life
Wide range of Power Pack used for different application of the user requirement
Single piece ram & piston design for easy maintenance
Suitable tool hanger fitted to positioning the tool at any angle for easy to operate
Operational Manual:
Check the hose and control cable connectors match with that of the Rod Cutter
Attach the hydraulic hose from the power pack to the machine properly so that there can be no leaking of hydraulic fluid
Connect the control cable from the power pack solenoid valve to the Rod Cutter
Connect the power cable of the power pack to a suitable wall mounted power outlet and switch on the power pack, do not press the switch on the handle of the Rod Cutter right now
Let the power pack idle (oil flowing from pump to tank) for a couple of minutes
Now place the rod to be cut between the moving and stationery cutter pushing the rod so that it touches the side wall of the housing
This is to ensure that the full diameter of the job is within the width of the cutters
Adjust the stopper screw so that the rod sits flat on the stationery cutter
Hold the job with a gloved hand and see that nobody is standing on the other side. Press the trigger
Wait for the moving cutter to retract fully before advancing the rod between the cutters for the next cut
Switch off the power pack and disconnect the power pack from the wall out-let after you finish
Maintenance:
Keep all the bolts tight and joints oiled at all times
Whenever the hydraulic fluid is changed, also change the filter and clean the tank before filling up
Never drop the machine which may cause serious damage to it
Safety Instructions:
As for any high power cutting machine, the following safety precautions should be strictly Observed during use of this machine:
Wear your safety shoes, gloves and safety glasses at all times. Remove oil or grease from your hand, tools and from the floor and area you will be working
Use proper cutting tool as per type, size and hardness of metal to be cut
While the machine is not in use, keep the power pack switched off, so that accidental pressing of trigger cannot cause any injury in case one keeps fingers between the cutters by mistake
See that nobody is standing on the other end of the rod, because depending on the tensile strength of the material and flow rate of the power pack, the parted portion of the rod may shoot out at high speed causing injury
Check that the balancer and hanging arrangement is strong enough to hold the combined weight of the cutter and the job Additional Information:Item Code: HRC-20
View All
