Product Description:
Features: Forged alloy steel used for cylinder & cylinder body Single return spring design Special quality sealing for specified pressure Easy to operate & maintain Light weight & compact design Unique design of cutters and special steel used for longer life Wide range of Power Pack used for user requirement Single piece ram & piston design for easy maintenance Suitable tool hanger fitted to positioning the tool at any angle for easy to operate Jaw thickness is 12 mm, this cutter is designed for critical operation where gap is narrow and limited space Can be operated by Hydraulic Power Pack or Air-Hydraulic Pump Operational Manual:Check the hose and control cable connectors match with that of the Rod Cutter Attach the hydraulic hose from the power pack to the machine properly so that there can be no leaking of hydraulic fluid Connect the control cable from the power pack solenoid valve to the Rod Cutter Connect the power cable of the power pack to a suitable wall mounted power outlet and switch on the power pack, do not press on the hand switch fitted in the handle of the Rod Cutter right now Let the power pack idle (oil flowing from pump to tank) for a couple of minutes Now place the rod to be cut between two jaws This is to ensure that the full diameter of the job is within two jaws Hold the job with a gloved hand and see that nobody is standing on the other side. Press the switch After cutting wait for the jaws are in opened condition Switch off the power pack and disconnect the power pack from the wall out-let after you finish Maintenance: Keep all the bolts tight and joints oiled at all times Whenever the hydraulic fluid is changed, also change the filter and clean the tank before filling upNever drop the machine which may cause serious damage to it Safety Instructions: As for any high power cutting machine, the following safety precautions should be strictly Observed during use of this machine: Wear your safety shoes, gloves and safety glasses at all times. Remove oil or grease from your hand, tools and from the floor and area you will be working Use proper cutting tool as per type, size and hardness of metal to be cut While the machine is not in use, keep the power pack switched off, so that accidental pressing on hand switch fitted in the handle can cause injury in case one keeps fingers between the cutters by mistake Additional Information: Item Code: HRC-17F
View All
