Product Description:
Features:
Heavy duty Pneumatic Steel Strap Sealer
Double Notch reverse type (up cut)
Easy to operate & maintain
Operational Manual:
Before connecting the pneumatic hose connector with machine please check the FRL is fitted with pneumatic hose line and the hose in safe working condition
Connect the pneumatic connector with the tool
Check the on line air pressure
Hold the tool vertically & place the jaws across the seal
This seal is very important as the seal crimped the off-center may cause the strap become loose & snap apart, possibly resulting in serious injury
Press the trigger to seal the strap
Remove the sealer & inspect the seal to verify the seal is properly holding the strap
The seal should have four impressions, two on each side
The notches should be centered on the seal. If impression isn''t properly formed, remove it & do it again with new seal & strap
Attempting to reseal will not ensure a proper seal & will decrease the break strength
Safety Instructions:
Only trained personnel should operate `SPDR-19`
Wear Gloves, Safety shoe, Helmet & Goggle before starting operation
Remove oil or grease from your hands, tools and from the working area
Keep fingers away from areas that can pinch or cut. These areas are primarily located at the front of the tool
Only use this equipment recommended for the strap.`SPDR-19` is recommended only for 0.79 mm to 0.89 mm thick. X 19.05 mm width
Additional Information:
Item Code: SPDR-19
View All
